Products

Products

Current: Home > Product > Outer wall

DE701 Copper Wall (single component)

  DE701  Exterior Wall  20kg/package

In view of the current widespread existence of rain penetration into the wall, resulting in moldy interior and exterior walls, wall blistering, coating shedding, time-consuming renovation, Digital Color launched a revolutionary strong waterproof and alkali-resistant exterior wall paint - Copper Wall & Iron Wall Series. This is a new patented exterior wall coating, which has the property of energy saving and environmental protection, easy operation, crack coverness, waterproofness and salt alkali resistance, diverse modeling and long weather resistance.


strong waterproofness;

strong salt and alkali resistance, can apply on mortar surface directly;

good suppleness, can cover crack;

excellent anti-ageing property, artificial climate aging resistance test for up to 800 hours, far beyond national standards;

wide range of color selection, can be toned;

labor and time saving, can exempt primer and topcoat.

Operation Instruction
  • Substrate treatment

    New wall: Remove dust greasy and loose marl on the surface. If holes are found, repair them promptly to ensure that the wall surface is clean, dry and smooth.

    Revonating wall: remove the weak paint film of the old wall, remove the dust powder and impurities on the surface, smooth and polish, clean and dry thoroughly.Surface status: Ensure that the surface humidity of the pre-coated substrate is less than 10% and the PH value is less than 10. The surface of the pre-coated substrate must be firm, dry, clean, flat and free of loose substances.

  • Application Area

    surfaces of building walls

  • Application methods

    brush / roll / spray

  • Dilution ratio

    According to the base condition, 0-10% water (weight ratio) can be added to dilute;

    Make sure to mix well and add the same amount of water to each package.

  • Drying time

    touch dry 0.5-1 hours

    actual dry 8 hours

    (25℃,relative humidity 70%)

  • Recoat interval

    Recoating interval time should be ≥6 hours, the thickness of the paint film should be uniform, no leakage and insufficiency

  • Theoretical coating consumption

    8-10 ㎡/kg/layer

    the coating consumption would be different according to the actual site condition.

  • Storage

    Store in a cool, dry place to avoid heat and frost

    A shelf life of 30 months if the product is unopened and properly stored.

  • Notice

    It is recommended to be transported and stored under the temperature above -5 degrees to avoid freezing deterioration;

    Please do not operate in wet or cold weather (temperature below 5℃, relative humidity exceeds 85%), otherwise the expected painting effect can not be achieved.

  • Special announcement

    The quality of the company's products abide by all the requirements of the national quality certification system.

    The product should be used under the instruction of the Company, in the event of adverse results because of product mismatching, improper use or abnormal environmental factors, the Company has the responsibility to provide solutions, but does not assume direct and joint liability.

    Before purchasing, users need to determine whether this product is suitable for your requirements to avoid waste.

    Any quality dispute shall be subject to arbitration by the national quality supervision and testing department.

  • Safety health environmental protection

    1.Should be kept out of reach of children;

    2.Necessary protection measures should be taken during construction to avoid inhaling dust and splashing into eyes. In case of intaking, wash with clean water immediately;

    3.Disposal of waste shall comply with the requirements of relevant environmental regulations.

  • Menu
Copyright @ 2024 Digital Color Coating CO.Ltd. All rights reserved
Technical Support: 祥云平台 Disclaimers